a piece of roofing rubber is stuck down along the joint between the plywood and the glass
dad bought a big roll of sheet metal
we rolled out the sheet metal and cut it off
two more times
first length of sheet metal attached. caulked along the bottom edge, nailed along the top edge.
bent over at the sides and nailed down
puppy supervised, and tried to get us to play keep-away with him
second length of sheet metal attached
third length of sheet metal attached. overlapping and bend over the back/north side. not yet bent over on the west side.
bending over the corner
a lot of cutting was done today. sawdust was everywhere.
puppy says pay attention to me! i have tennis balls here!
molly just says hi
all three sheets of metal on the roof
glass installed in the west window, and the upper milled piece installed to hold the glass in place
north wall glass and upper milled piece installed
close up of upper milled piece holding glass in place
east wall glass and upper milled piece installed
south wall glass and upper milled piece installed. upper milled piece was cut in three to install individually with each piece of glass
plywood cut and installed on the west wall
backer boards screwed into place from the outside
triangle piece cut for upper west wall
plywood cut for the north wall
plywood for the east wall
backer board for that seam installed
upper plywood for the east wall
inside view of the east wall. need to cut a backer board for this seam
No comments:
Post a Comment